Raising the value of freq is a good way for saving performance costs by avoiding to execute controllers or activate actuators more often than necessary.Įxamples: (Assuming the default frame rate with a frequency of 60 Hz (60 frames per second)).

It is only used at least one of the level triggering parameters are enabled. The default value is 0 and it means no delay. Freq Despite it's name 'Frequency', this parameter sets the delay between repeated triggers, measured in frames (also known as logic ticks).

The sensor will trigger with the delay (see parameter: frequency) of the sensor. If this is set, the connected controllers will be triggered as long as the sensor's state is negative. If this is set, the connected controllers will be triggered as long as the sensor's state is positive. The following parameters specifies how the sensor triggers connected controllers: True level triggering. A sensor triggers a connected controller as well when the sensor changes from deactivation to activation. When the sensor changes its state from negative to positive or positive to negative, the sensor triggers the connected controllers. A sensor triggers the connected controllers on state change. If a controller does not get trigger by any connected sensor (regardless of the sensors' state) it will not be activated at all. Iriver t10 driver software.Ĭheckbox button Sets active state of the sensor X Button Deletes the sensor. Pin button Display the sensor even when it is not linked to a visible states controller. It is used to access sensors with Python it needs to be unique among the selected objects. Sensor type menu Specifies the type of the sensor. They are organized as follows: Triangle button Collapses the sensor information to a single line (toggle). Common Sensor Options All sensors have a set of common buttons, fields and menus.

Toon edge blender game engine